Abu Dhabi Off-Road Club Forums

Hi

Appreciate your feedback and advice regarding the air beadlock system

Below link showing how it works

http://www.secondair.com.au/howitworks.htm

Bisho

Sent from my E6833 using Tapatalk

Hi Bisho

You can do something similar and very cheaply by fitting an appropriately sized very shallow inner tube and matching the width of your rim's inner width, but it must be somehow more rigid or reinforced (by some material to prevent over-inflation, I will call it belt), you will still need to drill a hole for the valve to add the 2ndary tube this.

If planned properly and carefully, it would work.

Testinwork wrote:Hi Bisho

You can do something similar and very cheaply by fitting an appropriately sized very shallow inner tube and matching the width of your rim's inner width, but it must be somehow more rigid or reinforced (by some material to prevent over-inflation, I will call it belt), you will still need to drill a hole for the valve to add the 2ndary tube this.

If planned properly and carefully, it would work.

Thanks a lot

Sent from my E6833 using Tapatalk

I don’t have personal experience with them but I will share what I heard.

They help reduce but not avoid pop outs. You will still get a pop out even with them installed and then it’s more work to put the tire back in place.

anTrax wrote:I don’t have personal experience with them but I will share what I heard.

They help reduce but not avoid pop outs. You will still get a pop out even with them installed and then it’s more work to put the tire back in place.

Thanks Hani

Sent from my E6833 using Tapatalk